Friday, 20 November 2026

T-Max gets a new seat cover

Back in 2017 I bought this 2006 T-Max with about 90,000km; since tthen she's been a good reliable work horse with a few issues caused by age and previous owner neglect. I have been wonding if the bike would die a few times, but all the problems so far have been easilly solved and not major.  

I finally got around to getting a seat cover for the 2006 T-Max because it had actually split (and my "repairs" looked crap):


Stripped off (pulling each of the staples out and many were rusted and snapped); you can see the seat is basically stuffed and leaking ...

So the foam is discoloured but otherwise still good. I left it in the sun a few days to dry.


I didn't take any pictures of the process (because it was a bit of a multi day struggle) but basically I slowly stretched the seat cover over the seat starting from the front and working out in the sun to keep it hot (but not too hot).




So then all that was needed was to refit it to the bike...






Notes

  • get a good stapler, if you want to get it neat you'll totally need something with a littl bit of a nose on the end to get into tight places
  • get the right staples, look at what you pull out, seek the same. Measure them and get a bit familiar with what staples there are (and trust me, staple sizes are a red hot mess)
  • get some medium size "bulldog clips" just wide enough on the back to clip onto the seat frame (which is plastic)
  • clip it on and work around it making sure that you keep checking its straight. I ended up with 12 clips around the back half to hold it all in the right spot
  • finally, when it looks good, remove a clip and staple there, work around like that
Best of Luck


No comments: